Structural Engineer Coventry

What RSJ beams in Coventry involve

When a load bearing wall is removed, the loads above need to transfer to the new beam and down to the foundations. A structural engineer calculates the correct RSJ size, specifies the padstones (the bearing pads under each end of the beam), and checks the masonry below can take the new load. This full calculation pack goes to Coventry Building Control before the builder can start.

RSJ beams Coventry calculations start from £245 and are delivered in 24 to 72 hours. The pack includes beam sizing, padstone dimensions and all connection details your builder needs. Wall removal guide

Builders beams Coventry: post-war construction

Many Coventry properties were rebuilt after wartime bombing. Post-war estates in Tile Hill, Cheylesmore, Wood End and Willenhall use no-fines concrete construction — a system where aggregate is used without fine sand, leaving a porous, low-strength concrete block. Standard beam calculations do not apply to these properties.

We identify no-fines construction from photos and site information before quoting, and factor the reduced bearing capacity into every padstone and beam design. This is a step that builders asking for a quick online quote often miss — and it is why Coventry Building Control can reject packs that do not account for it.

Victorian & Edwardian

Earlsdon, Styvechale. Solid brick walls, original floor joists, chimney breasts in most rooms. Careful checking needed before any wall removal.

1930s Semis

Coundon, Radford, Allesley. Cavity wall construction. Good candidates for kitchen knock-throughs and rear extensions. Standard padstone design applies.

Post-War Estates

Tile Hill, Cheylesmore, Wood End, Willenhall. No-fines concrete construction. Reduced bearing capacity — non-standard padstone design required.

New-Build Estates

Binley, Westwood, Canley. Modern trussed roofs and lightweight construction. Specialist loft conversion design needed — standard attic conversion methods do not apply.